ASSEMBLY
/ Disk installation and change
II.
DSU
II .
8 - 1 5
Page
For camera observation, use fluorescent mirror
unit of HQ type.
The fluorescent mirror unit type DSU-MRFPHQ
– accessory of this system – is dedicated for
camera observation.
8-13 Disk installation and change
For disk installation or change, you must do the works after you
verify that the disk entered into light path and then, you turn the
power of control box.
1.
Loosen screws (2) (2 places) at front side of access panel (1) located
on top of disk box, using the Allen screwdriver and remove the
access panel.
2. Loosen fixing screw from hole (3) located at left side of disk box,
using the Allen screwdriver and pull disk unit (4) upward.
Pull out disk unit gently so as not to hit disk unit with
inside wall of disk box.
3.
Loosen knob of disk unit (5) (2 places) and open disk cover (6).
4. In case that transportation lock knob is attached instead of disk,
remove the transportation lock knob first. (Regarding transportation
lock knob, see 8-4 Removal of transportation lock.) Pressing the
edge of disk, turn rotary shaft (7) in clockwise direction, using the
Allen screwdriver and remove disk attached to the disk unit (4).
5. Holding edge of disk, get out the disk that you are going to install
from the package without removing wrapper.
Note
Note
(1)
(2)
(3)
Note
(8)
(4)
