DMTA-10022-01EN, Rev. C, January 2015
Chapter 6
104
g)
In
INC 2ND BY
, select which parameter is to be incremented second (
POINT
,
TUBE
, or
ELEVATIONS
).
h)
Select
CREATE
.
Figure 6-25 Configuring the ID range for a boiler data file type
6.7.3
File Data Modes
When you create a data file on the 45MG, the file data mode must be selected in order
to determine which measured values are stored in the file (see step 2.
Data File” on page 92). Table 11 on page 104 describes the available file data-mode
options. Only one type of data can be stored in a file.
Table 11 File data-mode stored measurements
File data mode
Stored measurements
When to use
THICKNESS
Standard thickness
Echo-to-echo thicknesses
When using basic thickness-
measurement functions.
THRU COAT
Coating thickness
Material thicknesses
When using THRU-COAT (see
“Measurements with Optional
THRU-COAT, D7906, and D7908
Transducers” on page 76).
VELOCITY
Velocity
When performing velocity
measurements.
Содержание 45MG
