DMTA-10022-01EN, Rev. C, January 2015
Chapter 6
92
6.7.2
Creating a Data File
The following procedure describes how to create a data file in the 45MG.
It is also possible to create a 45MG data file from a computer using the GageView
interface program. Refer to the
GageView Interface Program — User’s Manual
(P/N:
910-259-EN [U8778347]) for details.
To create a data file
1.
In the measurement screen, press
[FILE]
, and then
select
CREATE
.
2.
In the
CREATE
screen (see Figure 6-17 on page 93):
a)
In the
FILE NAME
parameter, enter the desired file name using up to
32 characters.
b)
In the
DESCRIPTION
parameter, optionally enter a description of the
contents of the file.
c)
In the
INSPECTOR ID
, optionally enter an identification of the inspector.
d)
In the
LOCATION NOTE
parameter, optionally enter an identification of
where the measurements are performed.
e)
Select the appropriate data
FILE TYPE
for your application (see “Data File
Types” on page 93 for details).
f)
Select the appropriate
FILE DATA MODE
for your application (see “File Data
Modes” on page 104 for details).
g)
Set the
DELETE PROTECTION
mode to
ON
or
OFF
.
Delete protection locks the file so it cannot be deleted. You can unlock the file
for deletion using the file edit function.
h)
Depending on the selected
FILE TYPE
, refer to the following sections for the
remaining steps of this procedure:
•
INCREMENTAL
see “Incremental Data File Type”
on page 94
•
SEQUENTIAL
see “Sequential Data File Type” on
page 96
•
SEQ+CUSTOM PT
see “Sequential with Custom Point
Data File Type” on page 97
NOTE
Содержание 45MG
