DMTA-10022-01EN, Rev. C, January 2015
Software Options
97
Figure 6-19 Selecting the ID range for the sequential file type
6.7.2.4
Sequential with Custom Point Data File Type
The sequential with custom point (
SEQ+CUSTOM PT
) data file type is defined by a
starting and an ending ID number, plus a series of custom points. The resulting file is
inclusive of the start and end points, and all points in between. In addition, multiple
thickness readings per ID number location are assigned using the assigned custom
points.
Use the sequential with custom point data file type when you want, for example, to
measure along a pipe or tube on which, at each ID number location, you can take
measurements at the top, bottom, left, and right of the pipe (see an example in Table 9
on page 97).
Table 9 Resulting ID example for the SEQ+CUSTOM PT file type
START ID
END ID
Custom point
Resulting IDs
XYZ1267
XYZ1393
TOP
BOTTOM
LEFT
RIGHT
XYZ1267TOP
XYZ1267BOTTOM
XYZ1267LEFT
XYZ1267RIGHT
XYZ1268TOP
XYZ1268BOTTOM
XYZ1268LEFT
...
XYZ1393RIGHT
Содержание 45MG
