7
Table Tilt Adjustment
The tilt of the Olympic Dental Table may be adjusted to any angle up to 10 degrees by pressing on the Tilt Lever
I
while simultaneously lifting or lowering the end of the table closest to the lever. Releasing the lever will lock the
table at the desired tilt angle.
Caution: To avoid damage to the instrument tray
G
when tilting the table top, make sure the tray is not
directly beneath the Removable Drain Pan
P
.
Caution: To prevent the table from tilting suddenly, always maintain a firm grip on the table top while
depressing the Tilt Lever.
Instrument Tray Adjustment
The Instrument Tray travels up and down with the table top so that it is always at the same height relative
to the table surface. A double-arm design permits the user to move the tray to any desired location on either
side of the table.
The Velcro-affixed B-Tray is intended to remain in place permanently. Any standard size B-Tray will nest snuggly
in this tray and can be removed between procedures for cleaning.
Power
The Olympic Dental Table operates off suitable 120V/60Hz line voltage. A 5 port power strip with a 10' power cord
is mounted on the end of the unit under the base plate
D
. The lift’s motor is permanently plugged into one of
these ports. The other 4 ports are available as needed.
Moving the Dental Table
If at any time you wish to move the Dental Table, disconnect the Power Cord
E
and unlock all four caster brakes.
To unlock a caster, step on the brake release lever. When the caster is locked, a red window will be visible on the
caster.
CAUTION: The Olympic Dental Table is heavy and requires at least two people to move it. Move the table
slowly and carefully.
Cleaning
Removing the trough
L
for cleaning.
The trough may be removed either from the rear of the table or from
the front. To remove from the front, loosen the 4 head support thumbscrews
N
and
O
, tilt the head support
assembly
S
down slightly, then lift the trough out of the retention clip at the rear of the unit and slide it forward.
Removing the Drain Pan
P
for cleaning.
The Drain Pan support arms can be removed for occasional cleaning.
Unscrew and remove the 4 black knobs on both arms to remove the arms. After cleaning, replace the arms and
screw the knobs back in.
All stainless steel surfaces
can be cleaned with soap and water and ordinary disinfectants.
All painted surfaces, the Base, Lift Column, and Foot Switch
can be cleaned with soap and water and
ordinary disinfectant.
CAUTION: Do not let any liquid enter the Lift Column, as liquid can damage the lift mechanism
and electrical parts.
CAUTION: Make sure that knobs are cinched down as tightly as possible to prevent any movement.