6
Caution: To avoid damage to the Instrument Tray
G
while tilting the table top down, make sure it is not
directly beneath the Removable Drain Pan
P
.
Caution: To prevent the table from tilting suddenly, always maintain a firm grip on the table top while
depressing the Tilt Lever.
8.
Move the Instrument Tray to the desired location and place a clean instrument tray (size ‘B’) onto the
permanently installed base tray.
9.
When done, empty any collected fluids from the Removable Drain Pan
P
. To remove the pan, pull on the
Retention Knob
R
while sliding the pan out on its track. You may also wish to remove the Drain Trough
L
from under the table top for cleaning.
Operation
Loading/Unloading Patients
Caution: Be sure the Dental Table is located on a level surface and that all 4 casters are locked before
loading or unloading patients.
Caution: Do not use the Dental Table for patients weighing more than 250 pounds.
1.
Press the V-Positioner Lock Levers
J
and while firmly gripping the panels, slowly lower until flattened.
2.
Raise or lower the table top to the desired height for loading a patient by pressing and holding the indicator
on the Foot Switch
B
.
3.
Place the patient on the center of the table with its head over the Head Support
S
.
4.
Proceed with additional table adjustments. When a procedure is completed, the table should be returned
to a horizontal position with its 2 table V-panels flattened before removing the patient.
Height Adjustment
The height of the Olympic Dental Table is infinitely adjustable from 29" to 41" and may be adjusted at any time
during a procedure to provide maximum comfort to the operator or to provide better visualization or access.
The Foot Switch
B
is mounted on a swivel for easy access from either side, or from the back of the table. Simply
move the swivel with your foot until the Foot Switch is directly in front of you, then step on the foot control to raise
or lower the table.
V-Table Dorsal Positioning Adjustment
The table top on your Olympic Dental Table consists of two panels, each hinged at the center of the table.
Adjust the V-Table panels to the desired angle for dorsal positioning by depressing and holding each V-Positioner
Lock Lever
J
while raising the panel to the desired angle. Releasing the lever will lock the panel in place.
To flatten a V-Positioner panel, depress and hold the lever while firmly gripping the panel, slowly lowering the
panel until level.
The two panels are designed to operate independently and each can be adjusted to any angle
up to 45 degrees.
Tie-down Cleats
Mounted beneath each panel are 4 conveniently located Tie-down Cleats
K
.
Caution: To avoid patient sliding when table is tilted, Tie-Downs should be used.