background image

Page 2 from

 4

luminaire  will  change  between  maintained  or  no-
maintained  mode.  The  change  is  recorded 
permanently in it’s memory.

Indication  LED  status  (with  connected  mains 
power supply).

AC 

Charge 

On:  

              Good charge current.

Οff:    

            No battery (No charging current or 

disconnected battery).

Lamp fault

Οn:

                           faulty LED strip (must be 

checked by an authorized personel).

Off:

                           

Good LED strip.

Fault

 

Ο

ff

:

                                 

Battery OK. 

Blink

 (

With 

AC Charge LED

 ON

): Autonomy or 

low battery problem

(the battery must be replaced).

Blink

 

(

With 

AC Charge LED

 Off): 

                        

No charging current or disconnected battery

.

TEST
BUTTON

CHARGE
LED

FAULT
LED

LAMP 
FAULT
LED

INDICATION LEDs

ELECTRICAL CONNECTIONS

1

2

3

4

Dismantle the luminaire by pushing the lock/unlock button 
and slide the luminaire to the right and pull it down. 
Pass thru the cables from the entry hole and connect them 
as shown in the picture. 
Place upwards the luminaire and slide it to the left. The 
lock/unlock button appears indicating that the luminaire is 
securely installed.
Power on the device

.

 

 

SURFACE MOUNTING ON A WALL (single sided)

Install the included bracket on the wall (page 3) and 
perform the respective steps of the electrical connections.

CEILING INSTALLATION

Install the mounting base on the ceiling (page 3) and 
perform the respective steps of the electrical connections.

NOTE!! 
After finishing the installation you must power the luminaire 
at least for 24 hours for battery charging to perform the 
named autonomy. 

L

N

Cable

entry

hole

Gnd 

1

2

Installing the 

luminaire 

to the base

3

INSTALLATION INSTRUCTIONS

General

:

1. Operations for installation, maintainance or testing must be done by authorized personel only

.

2. 

The device must be connected to the mains power supply thru a fuse dependent by the total 

amount of the line’s  power load

.

3. 

In case of inactive use for a period greater than 2 months, disconnect the battery by pulling out 

the battery’s connector.

 

4. 

I s not allowed to discard batteries in to common trash bins, they must be discarded 

t i

only 

 

in battery recycling points. Do not incinerate.

922504461_09_002

Отзывы: