Page
2
from
2
duration
The replacement
of the battery and the light source must be done
u s i n g p a r t s o f t h e s a m e t y p e , b y t h e
manufacturer or by a competent person.
5.
t i
in battery recycling
points. Do not incinerate.
NOTE:
LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
0: Non-maintained
(*)
A: Including test device
*90: 1.5 hour duration
180: 3 hour duration
contact the installer.
In case of inactive use for a period greater
than 2 months, disconnect the battery by pulling
out the battery’s connector.
6.
I
s not allowed to discard batteries in to
common trash bins, they must be
discarded only
(*)
Non-Maintained operation: The luminaire
lights its illumination source,
only in power
supply’s failure.
Maintained operation: The luminaire lights its
illumination source, when it is powered by the
mains power supply or not
.
Battery replacement
.
It can be done only by a competent person and
after the mains interruption
.
1.
Follow the step 2
o
f the installation procedure.
2.
Disconnect the
cables
and remove the old
battery.
3.
Connect the new battery with the same type
(step
3
of the installation procedure) and place it
in the position
of the old one.
4.
Follow the step
5
of the installation procedure
and power the device.
923029009_09_005
INSTALLATION PROCEDURE (For wall mounting only)
1. Install the included mounting accessories to hook the device from the mounting holes (fig. 1)
.
2.
Unfasten the 4 mounting screws to remove the front plastic cover (fig. 1)
.
3. Make sure that the battery’s cables are connected to the respective poles. Black cable to (-) pole
and red cable to (+) pole.
4. Install the included cable gland or the rubber o-ring. Pass thru the mains cable and stabilize it by
fastening the cable gland. Connect the wires to the terminal blocks
L
for live wire and
Ν
for
neutral
.
The luminaire must be connected to a permanent electrical installation
to ensure
the
immobilization of the cable.
5.
Refit with care the front plastic cover, by fastening the 4 mounting screws (tightening torque
1Nm).
WARNING!!
After the installation has finished, charge the batteries for at least 24 hours so as to obtain
the rated autonomous duration
.
TEST
button
Cover
retaining
screws
Fig
.
1
Mounting holes
Charge
indicator
Power
indicator
3
4
L
N