Page
3 from
4
1
Unclip the plastic latches with a flat blade screwdriver, unfasten the 2 screws (not all the
way,
step 10 B
) and remove the diffusor. Place a flat blade screwdriver to the
recesses
and pull up gently the reflector.
2
Install the base plastic (with the included mounting screws and plugs).
WARNING
!!
To
preserve the
ΙΡ
65
rating, fit the screws with the metallic washers and plastic
rings
which are included.
3
Always use in any case round mains cable
,
with external diameter
of 5
-
10mm
(H05RN-F type 2x1mm²
or
any
other type
,
at least
equal
to it’s mechanical and
electrical properties).
ATTENTION!! The cable must not be deformed in any way (This requirement is
important to ensure the
ΙΡ
65
rating).
Install
the gasket and make a hole in the center by
using a small screwdriver. Pass the round cable through the gasket. Install the second
included gasket in to the unused hole.
4
Place the battery’s connector to the corresponding connector on the P.C.B
.
5
Connect the mains cables to the respective terminal block
.
6
Ν
for neutral
,
L
for live wire
and
L1
for the maintained operation
.
The
L
1
wire can be
connected
to an external switch to control the maintained or non maintained operation of
the luminaire
.
7
For permanent maintained operation use two wires to power the luminaire,
Ν
for neutral
and
L
for live wire, and link the
L
and
L1
.
8
Install the
included tie to fasten securely the power cables.
9
Refit the reflector (mind the holes of the indications).
10
Finally place the diffusor (mind the holes of the indications).
Attention!!
First the plastic
latches (A) must be secured
(click sound)
and then fasten the 2 screws (B)
(tightening torque 1.2 Nm)
.
INSTALLATION INSTRUCTIONS FOR WALL OR CEILING MOUNTING
8
5
4
Charge
Lamp fault
Battery fault
Indications
7
N
L
Link
Permanent maintained operation
6
N
L
External
Switch
Controlled operation of the lamp
10
A
A
B
B
923193903_09_003
9
1
2
3