7.9 Setting the service access code
The ninth selection in the technicians menu is
If ‘ENTER’ is pressed then the display shows
Use the numeric keypad to enter a new 4-digit access code for the technician. The
default technician
code is “1111”.
SET
SERVICE CODE
ENTER YOUR CODE
1111
7.10 Setting the service telephone.
The tenth selection found in the technicians menu is
If ‘ENTER’ is pressed the display shows
Use the numeric keypad to enter the technicians telephone number. This telephone
number will show on the display after every Fault condition on the panel.
All the programming selection described are valid only after exiting the programming
menu. In some cases when we exit the programming menu the panel conducts an
automatic RESET.
If we try to program an option on a device that is not on the network then the system
issues the following message on the display.
SET
SERVICE PHONE
SERVICE PHONE
UNIT IS
NOT CONNECTED
220 - 240 VAC / 50-60 Hz 50W
12V/7Ah lead-acid (Pb)
Stabilized power supply 13,8V/ 5OO mA
36 hours (without using the 24V output)
16 zones fully monitored of open and short circuit conditions
Two 24V circuits monitored for open and short circuit conditions
1 voltage-free ÁLARM RELAY contact, 1 voltage-free FAULT RELAY contact
o
0 to 60 C and 95% relative humidity
ABS ,Áëïõìßíéï êáé Polycarbonate
300 x 430 x 90 mm / 4.2Kgr
2 year
s
MAINS VOLTAGE
BATTERY TYPE
CHARGING CIRCUIT
DURATION
ZONE CIRCUIT
ALARM CIRCUITS
OUTPUTS
OPERATION RANGE
PRODUCED IN ACCORDANCE WITH
CONSTRUCTION MATERIAL
DIMENSIONS / WEIGHT
GUARANTEE
TECHNICAL CHARACTERISTICS
ENABLE
SIREN 1
With the numeric keypad and the ‘ENTER’ key select the required
SIREN output. The Display shows:
And the siren output is activated.
SIREN OUTPUT 1
IS ENABLED
ENABLE
RELAYS OF UNIT 1
With the numeric keypad and the ‘ENTER’ key select the required BS-
117 device. The Display show
s:
If ‘ENTER’ is pressed then all the relays of the BS-117 are
activated.
1234567890123456
ENABLE
RELAY (1/64) 01
With the numeric keypad and the ‘ENTER’ key select a specific relay (e.g
relay1) of the selected BS-117 device. The Display shows:
If ‘ENTER’ is pressed again then the chosen relay is activated.
1234567890123456
7.6 History record deletion
The sixth selection of the technicians menu is
If ‘ENTER’ is pressed then the history record of the system is deleted. All ALARM and
FAULT events are written in this record.
DELETE
HISTORY FILE
7.7 Automatic unit recognition
The seventh selection in the technicians menu is
If ‘ENTER’ is pressed the SETUP procedure described in section 5 commences.
AUTOMATIC
UNIT DETECTION
7.8 Setting the user code.
The eight selection in the technicians menu is
If we press ‘ENTER’ the display shows :
Using the numeric keypad enter the required 4-digit code that will be used as a user
access code. The default user code set is “0000”.
SET
USER CODE
ENTER YOUR CODE
0000
Date
File
Code
Page
09-
E
1116000.09-
E
19 from 20
Date
File
Code
Page
09-
E
1116000.09-
E
20 from 20
22
December
2004
22
December
2004
EN54, EN60335-1, EN 50082-1, EN 61000-3-2, EN 61000-3-3
