Page 2 from 4
Fault (Red LED)
Οn :
Faulty LED strip (must be replaced) or emergency
circuit (must be checked by an authorized personnel).
Blink (With Charge LED ON):
Autonomy or low battery
problem
(the battery must be replaced).
Οff:
No fault.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or testing must
be done by authorized personnel only.
2. The device must be connected to the mains power supply
through a fuse dependent by the total amount of the line’s
power load.
t i
in battery
recycling points. Do not incinerate.
Test and Faults Reset operations with the A-1900 card (not
included and available after request).
For lights test, you
must place the card in front of the TEST indicator and remove it
immediately. For Autonomy Test, you must place the card in
front of TEST and hold it for 5 to 10 seconds.
To reset errors you must place the card in front of TEST by
holding it for 10 to 15 seconds and removing it.
Only for models GR-750/ST/HP/LL and GR-751/ST/HP/HL
*
15m: When the luminary is installed on a wall.
**17m: When luminary is installed on the ceiling.
3. In case of inactive use for a period greater than 2 months,
disconnect the battery by pulling out the battery’s connector.
4.
I
s not allowed to discard batteries in to common
trash bins, they must be discarded only
923753000_09_001
GR-753/ST/LP/HL
220-240V /50-60Hz
RATED POWER: 4.6W/4.8VA
LUMINOSITY: 300lm
BATTERY:3.6V/3Ah
IP54
t 40ºC
a
t
º
5-40 C
MADE IN GREECE
8
1
0
X 1 A F
TEST
INDICATORS
GREEN:CHARGE
RED:FAULT
A-1900
