78.
Position and attach Mid Ridge Caps evenly spaced
on mid rafters. Align top to bottom as per
Step 77.
77.
Locate all
Ridge Caps
for Polygal Panels (3 Mid / 2 Outside / 2 Center). Starting from the out-
side, position both 5 1/2” wide caps so outside edge is aligned with edge of roof plywood and Cap end
slides under roof. Use a straight edge to aid in alignment.
See below.
When correctly aligned, attach
Caps to center of outside rafter with 6 - 1 1/2” finishing nails. Ridge Cap has nailing strip attached.
Plywood
and cap
evenly
aligned.
Ridge Cap slides against Roof Panel and has nailing strip attached to
outside underside of it. Strips allows facia to attach easier in
Step 80.
Cap overhangs rafter
end by approx. 1”
75.
Attach
Door Handle and Exterior Black
Drop Latch
to door. Handle is positioned on
top door, Drop Latch on bottom door. Attach
Black Drop Latch as illustrated above with 2” &
3/4” Black Screws. Note how female part of
Drop Latch is positioned higher than male. Do
a dry run first to position Drop Latch correctly.
Temporarily positioned Interior
Vertical Door Stop to help
align Interior Barrel Bolt.
2” Screws
3/4” Screw
Important:
Drill pilot holes with
1/8” drill bit prior to securing
with screws to prevent wood
splitting. On 3/4” screw, drill
shallow pilot hole only.
76.
Attach
Interior Silver Barrel Bolt
to inside of
door as illustrated above. Use 3/4” silver screws to
secure. Refer to
Step 88
to allow for adequate
clearance.
Align outside cap
so it is even with
outside of plywood
on roof.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 31
Center (2)
3 1/2” wide
Mid (3)
2 1/2” wide
Outside (2)
5 1/2” wide