6.
Carefully lower
(Part C) Girder with Deep
Notch Facing Down - 1 1/2” x 5 1/2” x 119”
down into notch of (B) girders. Be careful not
to twist the girder when positioning down into
place. Lag screw girder to post. Drill shallow
pilot hole first with 1/4” bit.
Use 2 washers
and lag screws.
7.
Lift, position and lag screw the second (C)
girder to posts.
8.
On level ground, position
1
Joist - 1 1/2” x 5
1/2” x 119” (Part D)
and
8
Stub Joists - 1 1/2” x
5 1/2” x 14 1/2” (Part E).
Joists are pre-marked
on top edge for stub joist and blocking positioning.
Make sure to flush bottom of stub joist with bottom
of joist. When complete, more important to have a
nice fit on bottom rather than top.
(C)
Girder
(C) Girder
Pre-marked for stub
joist placement.
D
E
Shallow notches
facing down.
C Girder
Note; Pilot hole post
first with 1/4” drill bit.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 6
Flush bottom of stub
with bottom of joist.
