22.
Locate an
Angled Wall Extendor
and
Top Siding Piece for Angled Wall Extendor (L/R)
. Position
top siding on wall extendor and align as shown above. Attach with 3 - 1 1/2” finishing nails to top wall
framing. There are left/right top siding pieces. Use rough surface side out.
Place finished wall extendor on side wall panel frame. Complete both sides now.
Note:
Bottom siding of wall extendor will overhang and cover siding of side wall.
20.
Locate
Door Header - Long
(2” wide aluminum support attached already). Align step on header
facing up and out and with support strip to the inside of shed. Attach using 2 - 2 1/2” screws per end as
shown above.
Hint:
Have 2 helpers push Side Walls together to close any gaps between Headers.
Complete both sides. Attach support strip to short headers with 2 - 3/4” screws.
21.
Locate both
Vertical Door Jambs
(1 1/2” x 3 1/2” x 73”) and position flush against front narrow
wall stud. The Jamb will sit flush to outside of wall siding
.
When positioned correctly, secure Jamb
using 6 - 2 1/2” screws. Complete both sides.
Push
Long Door Header has aluminum
support strip already attached.
3/4” screws
2 1/2” screws
5 1/2”
5 1/2”
Top Siding Pc.
Top Siding Pc. for Angle Wall
can also be installed after Roof
is attached after Step 46.
Side W
all Panel
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 13
