Note:
The floor will be flipped over and floor
runners will sit on your foundation. It is
important to note that having a level
foundation is critical. Choosing a foundation will
vary between regions. Typical foundations can
be concrete pads or patio stones positioned
underneath the floor runners.
9.
With Floor Runners attached, carefully flip
the floor over and place on your foundation.
Caution:
you will need 2 people to assist you.
Be careful when laying floor down not to bend
or twist floor. When in place, level floor
completely.
Concrete Slab
Foundation
Foundations
8.
Complete all Floor Runners.
Front
plywood
pushed together
at seams.
7.
Attach
Floor Runners
to completed floor frame.
There are 2 Floor Runners per 91” side and 5 complet-
ed runners in total. Use
3 - 2 1/2” screws
per Floor
Runner. Make sure Runners are flush with outside,
front and rear floor framing but not overhanging.
Parts (Steps 7 - 9)
Floor Runner Short
(1 1/2” x 3 1/2” x 31”)
x 5
Floor Runners Long
(1 1/2” x 3 1/2” x 60”)
x 5
Hardware (Steps 7 - 9)
S1
- 2 1/2” Screws
x 30 total
Parts (Steps 10 - 11)
Floor Plywood Small
(5/8” x 45 3/8” x 20 7/8”)
x 2
Floor Plywood Large
(5/8” x 45 3/8” x 74 7/8”)
x 2
Hardware (Steps 10 - 11)
S2
- 1 1/4” Screws
x 46 total
10.
Position
Plywood Floor
pieces
(4) on top of
completed floor joists. Plywood is cut slightly small-
er than floor framing. Keep plywood seams tight.
Door goes
on 96” side
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 9
