Note:
The floor will be flipped over and floor
runners will sit on your foundation. It is
important to note that having a level foundation
is critical. Choosing a foundation will vary
between regions. Typical foundations can be
concrete pads or patio stones positioned
underneath the floor runners.
9.
With floor runners attached, carefully flip the floor
over and place on your foundation.
Caution-
you will need 2 people to assist you. Be
careful when laying floor down not to bend or twist
floor. When in place, level floor completely.
Measure diagonal
in both directions to confirm
square.Both should be approximately 102 1/2”. Adjust
floor if necessary.
Concrete slab
foundation
Foundations
6.
Attach
Floor Runners 3 @ 1 1/2” x 3 1/2” x 70”
(Part 1C)
to completed floor frames. There are 3
floor runners per 70” side. Use
8 - 2 1/2” Screws
(Part B)
per runner.
7.
Make sure runners are flush with outside and
front and rear floor framing but not overhanging.
8.
Complete all floor runner attachments.
10.
Position
Plywood Floors - 2 pcs (Part 1D)
on top of completed floor frames as shown above.
The plywood is cut slightly smaller than floor framing. Align so plywood seam is tight.
Front
Center mid
runner
102 1/2”
Measure Diagonal
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 9
