Olsson and Brothers STROOT SPECTRE, Руководство пользователя и гарантия

Страница: 21 / 76

21
EN
MANTENIMIENTO E-SCOOTER
Read this information carefully to keep your E-Scooter up to date.
Each time you use your E-Scooter, we recommend you to keep the wheels, axles,
steering, handlebars, handlebar folding lever and display, clean and dry (do not wet
or clean with abrasive liquids).
Avoid getting your E-Scooter wet, this will result in the loss of warranty.
The tyre should be replaced when there is any sign of wear or breakage, on this case
you have to contact with the distributor to replace the original tyre-cover.
This scooter incorporates a braking system with wearing parts, such as brake pads
and brake discs. Monitor its condition, and if it’s necessary, visit an official center for
the replacement.Check the scooter for loose screws. If any are loose, tighten them.
Do not place scooters in the sun or other several wet places for a long time; please
keep the scooter clean.
Keep the rear brake disc clean to avoid breakage.
Warning:
Do not use alcohol, gasoline, kerosene, volatile chemical solvents or other
corrosive solutions to clean the vehicle. Failure to do so will cause serious damage to
the structure and/or internal elements. Do not wash the electric scooter under strong
water pressure, even if the scooter is switched off.
CHARGING AND MAINTENANCE OF THE LITHIUM BATTERY
Before using your E-Scooter for the first time, we recommend that you fully
charge the battery: connect the charger to your E-Scooter via connector on the
left side of the scooter base and plug the charger into the power supply. Do not
disconnect the equipment until the battery is fully charged. The battery display
indicates the battery charge.
The charging time of the battery depends on the amperage of each battery and
can take up to 5 hours.
When the battery is idle for a long time, charge it at least once a month.
Note: Damage to the battery due to ingress of water, collision, and other non
normal factors is not covered under warranty.
The charger is provided with a charge protection function, so that charging will
automatically stop when the battery is fully charged to 100%.
Connect the charger to the power supply outlet. (AC100V-240V). Do not use
other brands of batteries to avoid damage.
Do not open or disassemble the battery to avoid electric shock. Avoid contact
with metal objects to prevent a short circuit. Otherwise, the battery may malfunc-
tion or damage the user.
It is recommended to use an AC adapter, which comes in the original configura-
tion of the device, to prevent an accident or fire in the vehicle.
After each use of the device, charge the battery to extend its life.