Olsberg Orayonne plus, Инструкция по эксплуатации

Страница: 20 / 84

20
Construction
In order to optimally use the heat radiation effect, the
appliance should be installed as close the people re-
ceiving the heat as possible. The farther you are from
the device surface, the less the heat can be felt. Dis-
tances of approx. 1-3m are ideal.
q*?%#+<+;";":<;#=Y%\%%<*‚#;<<+:<—‚
IP24. This means that these appliances can also be
+"<%% +" <*#;;} +" <* ];" š ˆ \?_ ›Š_ Y#-
thermore, the installer must execute the building-side
connection in the protective type IP24.
ne
1
a) Si e ie
ne
0
ne
2
Dimensi ns in cm
ne 1
b) ie
ne
2
ne
1
ne
0
' ;
When assembling the appliance, an adequate bearing
capacity of the wall must be observed, corresponding
construction guidelines must be considered. In the case
of doubt, contact a building expert.
The heater may not be installed directly below a wall
outlet.
The glass panel consists of single-pane safety glass
(ESG). In contrast to conventional glass, this is consid-
#%— };# #+<"< " + +?" =;# +?"+\"<%—
higher powers of impact. Nevertheless, you should
avoid excess strains. In the case of damage, ESG will
break into many small parts with dull edges so that the
risk of injury is minimized.
Attention: All types of stress on the glass panel, wheth-
er by leaning of people or objects against it or other acts
of power, must be avoided!
Warning: The glass radiation convector may not be
used if the glass panel is damaged.
Minimum distances
q*=;%%;€+"?}+"+}Y}+<"<;=Y#"+<Y#"&}-
mable objects must be complied with due to safety rea-
sons:
upwards
Model 15/335, 15/336, 15/337....................... 15 cm
Model 15/338................................................. 40 cm
on the side .......................................................... 2 cm
below ................................................................ 10 cm
in front............................................................... 50 cm
To the back wall, there is a distance of 14 mm through
the wall holder.
Assembly of the wall holder
The wall holder is installed on the appliance before de-
livery. In order to install on the wall, the wall holder must
be removed from the glass radiation convector.
To do this, loosen the locked latches by pressing on
<*%=<"#+?*<;=<*+%;€+<*—;Y#\"?#ˆ
\?_šŠ"+}Y%<";Y%—#};:=#;}<*‚‚%+"_
By model 15/338, remove the safety chains from the
“cross slits”.
Remove the wall holder on the appliance bottom from
the appliance.
Ü
Ü
' <
Assembly order:
Orient the wall holder as a gauge on the desired posi-
tion on the wall with a level, press and draw the holes
ˆ\?_"Š_
Model A B
15/335 600 401
15/336 800 601
15/337 1000 801