Olsberg 14563, Инструкция по эксплуатации

Страница: 31 / 92

31
•
Remove the inside front panel (Fig.11):
14. Pull the inside front panel (E) upwards and
sideways out of the holding screws, left and
right. To do this, grip the panel on each edge,
above the air-outlet grill and push it carefully
upwards.
15. Tilt the panel forwards and pull it out and
away.
Caution: The insulation is fixed to the inside of the
panel – handle with care!
•
Insert the core bricks as follows (Fig.12 - 15):
The Styrofoam parts have been inserted to hold
the heating elements secure during transport. They
must be removed and disposed of in a suitable
fashion.
16. Remove the brick cover plate (F).
Caution: The cover plate is a functional part
of the heater and must be replaced
later.
17. Remove the left hand Styrofoam stopper.
18. Remove the top Styrofoam block.
19. Insert the first core bricks (G) at the bottom
left of the core, slightly lifting the lower heating
element to do this.
20. Remove the lowest Styrofoam block.
21. Carefully push the core brick to the right in
front of the side insulation, slightly lifting the
heating element to do this.
Caution: Take care when inserting all core bricks
that these are flush with the rear insula-
tion and also with the front step in the
floor insulation block.
Fig.11 Remove the inside front panel
Fig.12 Remove Styrofoam and cover plate
Fig.13 Insert the first core bricks
14.
14.
15.
E
17.
16.
18.
F
21.
20.
G