![background image](http://html1.mh-extra.com/html/oliver/model-777-n/model-777-n_users-operating-and-instruction-manual_3814733020.webp)
0777S20013
6-7
Tightening the Belt
CAUTION
OVER-TIGHTENING THE DRIVE BELT
MAY CAUSE BEARING OR MOTOR FAILURE.
Remove the crumb tray from the slicer. Locate the adjustment nut at the lower end of
the motor mounting plate, see below. Turn the adjustment nut clockwise with a wrench
to increase tension on the drive belt. To reduce tension, turn the adjusting nut
counterclockwise. The drive belt should be just tight enough, using moderate finger
pressure, to allow a 3/8 inch deflection halfway between the motor drive pulley and the
driven pulley.
Содержание MODEL 777-N
