Oliver 705-N, Руководство пользователя по эксплуатации и инструкция, Страница: 14 / 24

MODEL 705-N DUAL BLADE BUN SLICER
0705S20018
TROUBLE SHOOTING
WARNING
NEVER ATTEMPT TO CLEAN OR SERVICE THIS MACHINE UNTIL
IT HAS BEEN DISCONNECTED FROM THE POWER SUPPLY AND
YOU ARE SURE THE BLADES HAVE STOPPED.
THE SLICER MOTOR OR MOTORS WILL NOT START OR WERE RUNNING BUT
SUDDENLY STOPPED.
•
If both motors have stopped check to see if the machine's plug was accidentally
removed.
•
If plugged in, is the outlet working? Test it with another, working, small appliance.
•
Your slicer’s motors are equipped with thermal overloads. Should a motor become
overheated it will stop. (See “Resetting the Thermal Overload” below)
•
If you still can not find the problem have a qualified electrician check the unit's
motors and switch.
RESETTING THE MOTOR’S THERMAL OVERLOAD
•
To restart the machine allow the motor or motors to cool for approximately one and
one half to two hours. Then carefully tip the machine back so that you can press the
reset button. This button could be located on the end of the motor or on the end of
its conduit box. Press the buttons FIRMLY. Return the machine to its proper
position, connect it to the power supply and attempt to restart the machine.
NOTE
ATTEMPTING TO START THE MACHINE AFTER PRODUCT HAS BEEN
INSERTED IN THE MACHINE OR ATTEMPTING TO CUT PRODUCT
WITH A DIRTY BLADES MAY CAUSE OVERLOADS.