Oliver 4265C, Инструкция по эксплуатации, Страница: 15 / 71

4265C Jointer OLIVERMACHINERY.NET
15 |
Page
Electricals
WARNING
All electrical work must be done by a qualified electrician and must meet the
electrical code in your area.
Minimum Circuit Size Required for Model 4265C Jointer
Stock Number Minimum Circuit Size Required
4265C.101.4S 20A
4265C.102.4S 15A
Please ensure the electrical circuit for this machine meets the minimum circuit size requirement. The
minimum circuit size requirement applies to a dedicated circuit that provides power to one 4265C Jointer.
If more machines are sharing the same circuit, consult a qualified electrician to ensure the designated
circuit is properly sized for safe operation.
If a circuit is available, but not meeting the minimum circuit size requirement listed above, a new circuit
must be installed for this machine.
Grounding
WARNING
Improper grounding can cause electric shock, fire, and equipment damage.
Proper grounding reduces the risk to the operator in the event of electrical malfunction or breakdown.
This machine must be connected to the grounding conductor when available, and all grounding
connections must meet or exceed the electrical code requirements in your area. Furthermore, all grounds
must be verified and must meet or exceed the electrical requirement of the machine. If grounding is not
available, consider the use of a GFCI protection device as an alternative, if this complies with the electric
code in your area.
Electrical Wiring
This machine is not pre-wired with a cord and a plug. If you plan to connect the
machine directly to the electrical panel (“Hardwiring”). Please ensure there is a
readily accessible electrical disconnect near the machine. Refer to the section
“Wiring Diagram” for wiring your machine to a power source.
If you choose to connect this machine with a plug and a cord, please use a
UL/CSA listed plug. If you need an extension cord to connect to the power
outlet, select a durable cord type with a high-temperature rating (90C° or
above). Both plug and power cord must be sized to meet the amperage
requirement of your machine.