Oliver 1808-CE, Руководство пользователя по эксплуатации и инструкция

Страница: 32 / 63

1808-CE
1808S20011 8-1
MAINTENANCE PROCEDURES
WARNING
DISCONNECT FROM POWER BEFORE CLEANING OR SERVICING.
CAUTION
Only remove approximately one infeed section of the tray carriers at one time.
Removing all the tray carriers and advancing the conveyor can cause severe
damage to the machine.
LUBRICATION
The bearings used on the Model 1808 are of the type that do not require lubrication,
The conveyor main roller chains are rust resistant but an application of mineral oil
periodically is recommended. Frequency varies with each application, the duty cycle
and the operating environment.
WARNING
DO NOT ATTEMPT TO DO THE FOLLOWING STEP WHILE THE MACHINE IS
RUNNING.
Open chains on the drive train should be coated with a good, heavy duty (FOOD
CONTACT APPROVED) bearing grease. This can be done by wiping grease on both
sides of the chain. The grease will transfer from the chain to the sprockets thereby
lubricating the drive train. Check chains monthly for lubrication.
CHAIN TENSION
The chains should be checked for proper tension weekly.
DRIVE CHAINS
The drive chain should be taught so there is little or no backlash in the drive train. The
drive chain and its tensioner are located underneath the guard at the discharge end of
the machine.
MAIN CONVEYOR CHAINS
The main conveyor chains should be tight so as to prevent buckling of the chains as the
tray carriers come around the bottom of the head shaft sprockets at the discharge end of
the machine. If necessary, tighten the chains using the take-up units located at the in-
feed end of the machine. If
at all possible, try to tension both chains the same amount
so that the chains will be in alignment with each other and the tray carriers will run down
the conveyor square to the frame.