Oliver 10060, Руководство пользователя

Страница: 20 / 46

20 |
Page Oliver Machinery 10060/10061 Drill Press
6. Fit the squared end of the rack into the
friction ring of the base flange.
7. Secure the top of the rack by reinstalling the
rack collar. The tapered edge of the collar
should face down. Do not bind the rack or
over tighten the rack collar screw as that
may damage the column.
8. Slide the table crank handle (#11) onto the
worm gear shaft. Make sure the set screw
aligns with the flat surface on the shaft.
Tighten the set screw with a 3mm hex
wrench to secure the handle.
9. Have two people lay the headstock on the
floor on its side, then fit the column all the
way into the headstock.
IMPORTANT
Do not lift the heavy headstock by the
power switch or the power cords. Doing so
may damage the machine.
10.
Tighten the set screws on the headstock to
temporarily secure the headstock to the
column.
11. With two people, lift the drill press by the
headstock. A third person may be needed to
keep the base on the ground from sliding.