Olimpia splendid UNICO EASY S1, Инструкция по эксплуатации и техническому обслуживанию

Страница: 53 / 180

UNICO EASY S1
ENGLISH
EN - 19
3.9 VENTILATION MODE (FAN)
a . When this mode is selected, the appliance doesn’t perform any action both on temperature or on air
humidity in the environment, but only maintains it in circulation.
b . this mode can be selected by pressing the key “ MODE ” once or more (on the remote control or on the
control panel) until when the specific icon is shown on the display of the control panel and/or of the remote
control.
- icon on the control panel - icon on the remote control display
c
. in this mode, the fan is always switched on and it is possible to select its desired speed by pressing the
key “ FAN ” on the remote control or the key on the control panel.
d . the fan speed is displayed as indicated in paragraphs “3.1” (point SW7) and “3.2” (point d7).
3.10 HEATING MODE (HEAT)
(only for version with heat pump)
a . When this mode is selected, the appliance heats the environment.
b . this mode can be selected by pressing the key “ MODE ” once or more (on the remote control or on the
control panel) until when the specific icon
is shown on the display.
c
. in this mode, the fan is always switched on and it is possible to select its desired speed by pressing the
key “ FAN ” on the remote control or the key on the control panel.
the fan speed is displayed as indicated in paragraphs “3.1” (point SW7) and “3.2” (point d7).
d . the temperature set-point is included between 17°C and 30°C (from 62 f and 86 f) with 1°C variations
and it can be set using the keys +/- on the control panel or with the keys ▲ ▼ on the remote control.
e . after a certain time (maximum three minutes) after the activation of the operation mode, the heat pump
activates and the appliance starts delivering warm air.
f . Connect the condensation discharge pipe (paragraph 2.8)
3.11 TIMER MODE
a
. this mode allows to program the switching on or the switching off of the appliance.
b
. the delay time can be set, activated and cancelled both from the remote control and from the control
panel.
3.11.a Programmed switching on
a
. When the appliance is in standby mode, select the operation mode, the desired temperature and ventilation
speed.
- on the control panel: - press and set the switching on delay time with the keys +/-
.
- to activate the function, press or wait approximately 5 seconds so that
the set time on the display stops flashing (the display returns to showing
the environment temperature).
the icon lights up.
- on the remote control: - press the key “
TIMER ON
” to access the function and then press the key
“
TIMER ON
” once or more until the switching on delay time is set.
- Direct the remote control towards the appliance; a beep confirms the acti -
vation of the function.
- the icon on the control panel and the indicator “ Timer On ” on the remote
control display light up.