5
• Material: High quality, impact and UV-resistant ABS colour RAL 9010.
• Design front cover removable for cleaning without the use of tools.
• Rear reinforcement ring to prevent spigot deformation during installation.
• High efficiency aerodynamic fan with “winglet” blades to optimise quietness and
efficiency.
• Single phase EC Brushless motor with integral thermal protection.
• Motor mounted on high quality ball bearings.
• The fan is double insulated: no earth connection is required.
• Trickle speed selectable during installation: 6, 8, 13 l/s or off.
• Option to boost from trickle (or from off) through LS connection or pull cord (only pull
cord versions).
• Installation type selection available (through wall or ducted).
• Timer and Integral Humidistat versions available.
• IPX4 degree of protection.
• Power supply 220V to 240V~ 50/60Hz.
TECHNICAL SPECIFICATIONS
• Ensure adequate air return into the room in compliance with existing regulations in
order to ensure proper device operation.
• If the environment in which the product is installed also houses a fuel-operating device
(water heater, methane stove etc., that is not a “sealed chamber” type), it is essential
to ensure adequate air intake, to ensure good combustion and proper equipment
operation.
• Install the product so that the impeller is not accessible from the air outlet side as
verified by contact with the Test Finger (test probe “B” of the norm EN61032) in
compliance with the current safety regulations.
• Ceiling installation
In order to guarantee the IPX4 degree of protection against moisture in case of ceiling
installation, use the appropriate ceiling mount kit, which is not included. Use only the
rear entry hole for supply cables. If there is a possibility of condensation along the air
discharge duct, provide a drainage system to prevent condensation from discharging
into the environment through the fan.
Attention: do not mount the product on the ceiling without this kit.
• Window installation
In case of window installation it is necessary to use the appropriate window kit, which
is not included.
Attention: do not mount the product on the window without this kit.
Model
Airflow
Static pressure
Pa max
Power
W max
Sound pressure
dB(A) @3m
SITALI SFE 100
m
3
/h
l/s
27
2,5
26/23/13/11
83/47/29/21 23,1/13/8/6
INTRODUCTION
SITALI SFE 100 (fig. 1) is a decentralised mechanical ventilation unit designed to ensure
air extraction in small/medium-sized rooms.
Suitable for air discharge directly to the outside or in the presence of short ducted system.
Wall, ceiling or window installation (fig.2).
