Olimpia splendid LIMPIA HERO, Инструкция по эксплуатации и техническому обслуживанию

Страница: 24 / 148

EN - 8
ENGLISH
If calcium becomes difficult to remove with a paintbrush:
• Fill the tank with the mix of 1 spoon of white vinegar and 1 spoon of water.
• Let solution stand for 5 minutes.
• With the vinegar inside the tank, clean all the internal surfaces with a soft cloth or a brush to help removing limescale.
• Also check mist nozzle and mist tube in water tank. Clean as needed.
• Rinse the Base thoroughly with water to remove scale and vinegar solution.
4.1 - END OF SEASON STORAGE
• Follow the Cleaning and Descaling instructions when the humidifier will be stored at the end of the season.
• Dry the humidifier completely before storing. DO NOT store with water inside the bowl or Water Tank.
• Pack the unit in its original carton and store in a cool, dry location.
If you experience a problem do not attempt to open the motor housing yourself. doing so may void
your warranty and cause damage to the humidifier or personal injury.
5 - TROUBLESHOOTING GUIDE
PROBLEM SOLUTION
Water vapor and humidity are not
produced.
• Power plug: Unplug and then try again.
• Power Failure: When the power is returned, try again.
• Tank Installation: Make sure the tank is correctly attached.
• The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
Air blows but water vapor is not
produced.
• Excessive Water: Remove a certain amount of water from the tank.
• Detergent residue and/or oil ingredients from cosmetics, etc may be in tank; wash out
tank and try again.
• The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
• If you use hard water, replace with softer water.
Humidity level is low. • The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
• The water in the unit is too cold: Replace with cool, but not cold water.
The humidity has a bad smell. • Poor maintenance or dirty water: Clean the product thoroughly, and fill it with fresh
water.
White dust is forming on nearby
furniture.
• Hard water may deposit a certain of dust. Dust in the air also settles because of added
humidity in the room. Use distilled water if this becomes a nuisance.
Unit has stopped working. • No or low water. Unplug unit and refill tank.
Water is accumulating outside of
unit or area surrounding unit.
• Saturation of humidity. Lower mist control setting.
• Unit not level and water is accumulating. Unplug and place on level surface. Point
spray away from objects. Raise unit on a water-resistant level surface at least 60 cm
from the floor.
Water dripping when refilling. • Water remaining on bottom of tank. Wipe tank or tilt to drain before transporting.
Increased noise level. • Unit must be placed on a flat, level, hard surface. Make sure it is NOT placed on a soft
or absorbent surface.
Flashing light symbols. • Indicates low water. Unplug and refill tank.