Olimpia splendid DUAL INVERTER 14, Инструкция по эксплуатации и техническому обслуживанию

Страница: 78 / 352

min.
300
mm
min.
300
mm
min.
600
mm
min.
300
mm
min.
700
mm
min. 600
mm
A
B
C
D
C
F
A
E
IN
IN
OUT
F
1
F
2
X
4
"F1" 340 350 403 403
"F2" 614 540 673 673
ENGLISH
EN - 22
mode.
2.6.2 - Outdoor unit assembly
Proceed as follows (as described in the previous paragraph), once the ideal position for installation of the
outdoor unit has been identified:
a
. Position the unit on the support base, respecting the drilling distances indicated in the table in figure X4.
b
. Screw any clamping nuts, without tightening completely.
c
. Using a spirit level, check the unit is level; if necessary, adjust the support feet.
d
. Tighten any clamping nuts correctly.
IN
= air inlet -
OUT
= air outlet
e . If the outdoor unit is higher than the indoor units, to prevent rain entering, a downward bow must be made
along the connection pipe (siphon) before the connection pipe enters the wall. This is to guarantee that
the lowest point of the connection pipe is outdoors.
2.6.3 - Execution, installation and connection of the refrigeration lines
Do not make the connections using normal hydraulic piping, which could contain
scrap residues, dirt or water, and which can damage the unit components and
jeopardise correct operation of the appliance.
• Another option (figure 16) is to position the gasket (6) on the fitting (5) and then insert the latter into the
hole made on the bottom of the outdoor unit and turn it by 90° to fix it securely.
• Connect a rubber hose (not supplied) to the fitting (6) if water is drained from the outdoor unit in heating
Model
DUAL
14/18
1x2
TRIAL
21/26
1x3
QUADRI
28/36
1x4
PENTA
42
1x5