Olimpia splendid Bi2 WALL AR 1000, Инструкция по эксплуатации и техническому обслуживанию, Страница: 59 / 317

Bi2 WALL AR 1000/1200/1400
EN - 23
ENGLISH
Led status Mode of operation
Off Board in Stand-by (contact CV open)
On Board on (contact CV closed)
1 Blink
Temperature H2O > 20°C in summer mode or
Temperature H2O < 30°C in winter mode
2 Blinks Motor locked/disconnected or safety grille open
3 Blinks
Water temperature sensor open or short circuited
4 Blinks
THIS SIGNAL IS NOT AN ALARM
At every start-up, the system checks the software version of the
power board
5 Blinks The motor feedback indicates a speed > 1400 rpm
6 Blinks
The motor feedback indicates a speed < 100 rpm
(see locked fan function)
5.1 - HOT/COLD GENERATOR SWITCHING ON CONSENT CONTACT
The screw connector (C) on the black and grey cables of the thermoelectric head is a
free contact (closed = valve open, 230 V max, 1 A max) to give consent for switching
on of the hot/cold generator.
5.2 - CONFIGURATION
Disconnect power feeding from the board before config
J1 - MOUNT
ON: Installation of the high wall unit.
OFF: Not used.
J2 - SEL1 and J3 - SEL2
SEL1 SEL2
OFF OFF Not used
OFF ON Not used
ON OFF Units with Flap
ON ON Not used
Only at first start-up of the board, for approximately 3 seconds, the relay of the
valve carries out a series of commutations to confirm the selected configuration.
Once the operations have been completed, reposition the previously disassembled
parts taking care to connect the earth connection cable. Secure the front panel by
means of the screws, then power the machine.