OLIMEX STM32-E407, Руководство пользователя

Страница: 14 / 33

OLIMEX© 2018 STM32-E407 user's manual
CHAPTER 6 CONNECTORS AND PINOUT
6. Introduction to the chapter
In this chapter are presented the connectors that can be found on the board all together with their
pinout and notes about them. Jumpers functions are described. Notes and info on specific
peripherals are presented. Notes regarding the interfaces are given.
Note that slashed signals (xxxx/yyyy) in the tables below might mean either multiplexing between
signals or port name correspondence on the processor.
6.1 JTAG/SWD debug
The board can be debugged from the 20-pin JTAG connector either by a JTAG or a SWD
compatible debugger. Below is the table of the JTAG. This interface can be used with the Olimex's
OpenOCD debuggers.
JTAG/SWD interface
Pin #
Signal
name
Pin #
Signal
name
1 +3.3V 11 -
2 +3.3V 12 GND
3 PB4/TRST 13 PB3/TDO
4
GND
14
GND
5 PA15/TDI 15 PB4/TRST
6 GND 16 GND
7 PA13/TMS 17 -
8
GND
18
GND
9
PA14/TCK
19
+5V_JTAG
10 GND 20 GND
6.2 SD/MMC slot
The microSD card slot is a standard 8pin connector.
We have tested a number of microSD cards on the STM32-E407 boards and all of them worked fine
regardless manufacturer or capacity. However, keep in mind that some of the lower quality
microSD cards might draw too much current from the slot which might cause power-state problems.
If you suspect the microSD card is causing problems please try using another one of better quality
for better results.
Page 14 of 32