OLIMEX© 2012
PIC32-PINGUINO-MX220 User's Manual
CHAPTER 7
HARDWARE
7. Introduction to the chapter
In this chapter are presented the connectors that can be found on the board all together with their
pinout. Proto area is shown. Jumpers functions are described. Notes and info on specific peripherals
are presented. Notes regarding the interfaces are given.
7.1 Battery connector
Pin #
Signal Name
1
VBAT
2
GND
7.2 ICSP pin holes
The 6 pin ICSP header provides interface for custom programming/debugging outside of the
PINGUINO IDE. Note the pin holes doesn't have a connector mouted over – you have to mount
it/solder it yourself. The pinout can be found in the table below. It is important to check the jumper
configuration for proper use of the ICSP pin hole .
ICSP pin holes
Pin #
Signal Name
Pin #
Signal Name
1
RESET
4
PGED3
2
+3.3V
5
PGEC3
3
GND
6
Not connected
Page 17 of 28
