OLIMEX© 2015
OLIMEXINO-5510 user's manual
CHAPTER 6: CONNECTORS AND PINOUT
6. Introduction to the chapter
In this chapter are presented the connectors that can be found on the board all together with their
pinout and notes about them. Jumpers functions are described. Notes and info on specific
peripherals are presented. Notes regarding the interfaces are given.
6.1 SBW (Spy-Bi-Wire) debug connector
The SBW interface is used to program and debug the board. It is also known as “2-wire JTAG”.
“NC” stands for “Not Connected”.
SBW interface
Pin #
Signal Name
Pin #
Signal Name
1
NC/TI_RST*
8
OLI_TST/NC*
2
NC/P_IN**
9
GND
3
NC
10
NC
4
P_OUT/NC*
11
OLI_RST/NC*
5
Not connected
12
NC
6
Not connected
13
NC
7
NC/TI_TST*
14
NC
*The information lines can be switched via the SMD jumpers TI_RST/OLI_RST and
TI_TST/OLI_TST. This might be required for different programmers. If you use Texas Instruments
programmer switch them to TI_RST and TI_STS. If using Olimex programmer switch to OLI_RST
and OLI_TST. By default they are in Olimex position.
**The Pin/Pout jumper declares if the board is internally powered or has to be powered externally
(via SBW programmer).
Page 15 of 28
