Oleo-Mac OS 530 ERGO, Инструкция для оператора, Страница: 23 / 84

19 - 80
3 - TECHNICAL SPECIFICATIONS
3.7 Components of the machine
POS. DESCRIPTION FUNCTION FIGURE
1 Machine data plate Carries identification data for the machine A
2 Starter recoil handle Pulled to deliver spark and start the engine A
3 Internal combustion engine Drives the rod and hook A
4 Anchor lug Point where the harness is attached to the machine A
5 Handle Handgrip incorporating throttle trigger and lockout switch A
6 Anchor lug Point where the harness is attached to the handle A
7 Muffler guard Protects the operator from burns A
8 Oil level sight glass Allows visual check on oil level A
9 Oil filler plug Removed to allow top-up of oil in the gear case A
10 Handle lockout switch Main lockout switch used to select engine start or shut-off C
11 Filter sticker Indicates the filter servicing interval C
12 Throttle trigger Accelerates/decelerates the engine C
13 Hip guard Protects the operator from the movement of the machine C
14 Fuel tank Contains the fuel needed to run the engine C
15 Fuel filler cap Removed to allow refuelling. Replaced and tightened to prevent C
escape of fuel
16 Shaped handle Used to hold the machine in position D
17 Rubber grip Facilitates handling of the machine D
18 Foot Supports the machine when set down D
19 Rod guard Protects the operator from the movement of the rod when coupled D - E
20 Seal Prevents lube oil from escaping E
21 Nut Locks the extension rod E
22 Hook Transmits shaking action to the branch H - I
23 Rod grip Used to manoeuvre the extension rod H
24 Extension rod Connects the hook to the machine at the required distance E - H
25 Hook pins These carry the rollers which protect the branches I
26 Hook clamp screws Used to secure the hook to the rod I
27 Hook rollers Designed to protect the bark when the branch is shaken I
28 Air filter Traps impurities in the flow of air cooling the engine M
29 Muffler The silencer from which exhaust gases are emitted N
30 Priming bulb Engine starting aid, pressed repeatedly to prime the carburettor O
31 Idle set screw Used to adjust the engine idle speed P
32 Choke lever Used to facilitate starting when the engine is cold P
33 Engine cylinder Figure illustrates maintenance Q
34 Buckles Used to adjust the length of the harness straps R
35 Harness Takes the weight of the machine R
36 Fuel filter Traps impurities in the fuel S
37 Spark plug Provides engine ignition T
38 Plug electrodes Gap determines correct operation of the plug T
- Protective clothing Operator must wear the items of clothing illustrated B
- Positioning the machine Figure shows the positioning of the machine when held by the operator F
- Gripping the machine Figure shows how the rod is twisted by the operator to engage the G
branch
- Cleaning the cylinder fins Figure shows how to clean the cooling fins of the engine cylinder L