User Manual LR-1BS2
OMEN-1BS2-202202
25
Figure 26 Light emission position of LR-1BS, LR-1B, LR-1F
Appendix G
Cleaning of sensor
OLE-LiDAR, especially the ring-shaped protective cover, should be kept clean in order
toaccurately sense the surrounding environment.
G.1 Notice
Please read Appendix F thoroughly and carefully before cleaning OLE-LiDAR, otherwise
improper operation may damage the equipment.
G.2 Materials required
1. Clean fiber cloth
2. Neutralsoap spray
3. Clean water spray
4. Isopropanol solvent
5. Clean gloves
G.3 Cleaning method
If there is only some dust on the surface of LiDAR, directly use a clean fiber cloth with a
small amount of isopropyl alcohol solution to gently wipe the surface of the LiDAR, and then
wipe it with a dry and clean fiber cloth.
If there are mud or other blocky foreign matter on the surface of LiDAR, first spray clean
water on the surface of the dirty part on the LiDAR to remove the mud and other foreign
matter (
Note:
please do not wipe off the mud directly with a fiber cloth, as this may scratch the
surface, especially the surface of the protective cover). Then spray with soapy water on the
dirty parts, since the lubricating effect of soapy water could accelerate the separation of foreign
materials. Gently wipe the surface of the LiDAR with a fiber cloth, be careful not to scratch the
surface. Finally, clean the soap residue on the LiDAR surface with clean water (if there are still
residues stains on the surface, use an isopropyl alcohol solution to clean it again), and wipe it
with a dry microfiber cloth.
