4
resulting from improper installation or operation, can settle on surfaces outside
the fireplace.
(n) Note: Installation and repair should be done by a qualified service person. The
appliance should be inspected before use and at least annually by a qualified
service person. More frequent cleaning may be required due to excessive lint
from carpeting, bedding material, etc. It is imperative that the control
compartment, burners and circulating air passageways of the appliance be kept
clean.
(o) An unvented room heater intended for installation in a solid-fuel burning
fireplace shall comply with these instructions.
(p) This heater is equipped with a PILOT LIGHT SAFETY SYSTEM designed to
turn off the heater if not enough fresh air is available.
(q) DO NOT TAMPER WITH THE PILOT LIGHT SAFETY SYSTEM
(r) If heater shuts off, do not relight until you have provided fresh air. If heater
keeps shutting
off,
have it serviced. Keep burner and control compartment clean.
Call your installer or Old Salem Hearths.
(s) It is critical that the burner be installed level to prevent sooting
WARNING: Do not use this room heater if any part has been under water.
WARNING: When used without adequate combustion air, heater may give off
CARBON MONOXIDE, an odorless, poisonous gas.
WARNING: Failure to keep the primary air opening(s) of the burner(s) clean may
result in sooting and property damage.
WARNING: State or local codes may not allow operation of unvented appliances.
Check your state or local codes.
WARNING: Any outside air ducts and/or ash dumps in the fireplace shall be
permanently closed at the time of appliance installation.
WARNING: Any glass doors shall be fully opened when the appliance is in
operation.