7
8.
TUBE-B (x1)
Transparent silicon 4mm I.D. tube with a PTFE filter in the middle connected at both ends to a
blue rigid tube 6 mm O.D.. Use TUBE-B to connect OKO-AP to the air input port on the rear panel of 2GF-MIXER.
9.
2GF-MIXER (x1),
manual Mixer to mix Air and CO2.
10.
Pressure Gauge for CO2 (x1).
Install pressure gauge between the pure CO2 supply pressure regulator and
the corresponding CO2 input port on the rear panel of 2GF-MIXER.
11.
TUBE-A(x1)
. Transparent rigid tube 6mm O.D.. Use TUBE-A to connect the output port of the pressure gauge
to the CO2 input port on the rear panel of 2GF-MIXER.
12.
TUBE-C (x1).
Blue rigid tube 6mm O.D. connected to a 4mm I.D. silicon transparent with a PTFE filter in the
middle. Use TUBE C to connect the gas output of the GR-REGULATOR to the gas input connector of Humidifier.
13.
Humidifier (x1
). It is composed of a glass bottle, Humidifier Bottle, with TUBE E (6 mm OD silicon tube with
a glass bubbler at the end) and its heater, Humidifier Heater.
14.
Heated Tube (x1).
Use Heated Tube to connect the Humidifier to Okolab H301 incubating chamber.
15.
Okolab H301 incubating chamber (required, to be ordered separately).
16.
OBJ-COLLAR (optional)
1
4
6
2
5
7
12
16
8
9
13
14
15
3
10
11
To CO2
supply
Figure 3. UNO-T-H-CO2 Equipment Overview.
