Operating modes
23
6.1 Bionic Scan
In order to make a scan with the Bionic X4 first turn on the unit with the power button located on the
left side. After switching on the unit you will see in the display „Bionic Scan | Start ->“. Confirm this
function by pushing on the green multi-function button. Then the Bionic X4 will have to be calibrated to
your body's own natural bio-energy.
6.1.1 Calibration
In order to calibrate the Bionic X4 be sure that your hands are in contact with the electrodes. Figure 6.2
shows an example of how to hold the unit.
Turn the calibration control from one side to the other very slowly until a higher value is seen. The
upper value of 255 is too high and must be lower. For the optimum range a good setting is between 220
and 254. This value will make the unit very sensitive to buried gold.
The higher the unit is calibrated to the more exact it will look for gold. Wait then a couple of seconds so
that the value is stable before pushing the green button. The shown frequency needs to be stable before
OKM GmbH
Figure 6.2: Contact between operators hand and the electrodes
WRONG
WRONG
RIGHT
RIGHT
Figure 6.3: Calibrating the device in bionic mode