19
To delete a character in the input line, select the character so that it blinks. Then move
the cursor to CLR on the command line and press Enter.
To position the camera ID on-screen, move the cursor to POS and press Enter. The
menu will then disappear on-screen and the camera ID will be displayed on the monitor.
Use the menu button to move the camera ID to the desired position. Press Enter. The
menu will reappear. Select Return to return to the previous menu.
Protocol:
Two protocols are available for remote control – with a RS485 controller or
keyboard Pelco-D and Pelco-P – use LEFT or RIGHT to choose the protocol.
User can setup Camera title, Digital effect (Freeze, Mirror, V-FLIP, Rotate, D-ZOOM,
GAMMA), RS485 which is very useful to connect test monitor, DVR or keyboard to do
the camera setting (Gamma ratio, Negative image effect, Motion detection, Privacy
mask and language choice). SYNC INT is only in 12V DC power source. SYNC INT and
L/L (line lock) are in 24V AC.
The key combination to enter the camera’s OSD menu with OKINA USA’s RS485 PTZ
controller PTZ-KB250X is SET + 95 + PRESET and for PTZ-KB050X is
95+ENTER.
The protocol must be set to Pelco-D (not P)
For other RS485 PTZ controllers, the key combination may be different. If you have
trouble accessing the camera OSD, first check the wiring for polarity and continuity, then
please contact your reseller tech support. Note that there are a lot of different RS485 PTZ
controllers in the market, so our tech support staff is limited to only a few brands. The best
option is to use OKINA USA’s RS485 PTZ controllers.
RS485 PTZ Controller Key Combination to Enter OSD Menu
1. PTZ-KB250X
SET + 95 + PRESET
2. PTZ-KB050X
95 + ENTER
OSD Control:
Button / RS485 Control keyboard/
Communication Pelco D
RS485:
This function allows you to configure the camera’s RS485 protocol settings.
1.
Camera ID:
set the camera ID. The values range from 1 to 255.
2.
ID display:
enable or disable the id display on screen. Press LEFT or RIGHT
enable or disable.
3.
Baud rate:
set the baud rate between camera and controller. The values range
from 2400 to 57600.
RS485
1. CAM ID
2. ID DISPLAY
3. BAUDRATE
4.
RETURN
1
OFF
9600
RET
↵
