8
Switch State
Protocol
P0
(Pin 1)
P1
(Pin 2)
OFF
OFF
PELCO-D, 2400 bps
ON
OFF
PELCO-D, 9600 bps
OFF
ON
PELCO-P, 4800 bps
ON
ON
PELCO-P, 9600 bps
If you want to control using DVR or P/T controller, the protocol must be
identical to the camera.
If you change the camera protocol by changing the DIP S/W, the change will
be effective after you reboot the camera.
Factory default is Pelco-D, 2400 bps
Pin 3 and Pin 4 is only for supplier’s use.
Do not change the original
settings
for these two pins, otherwise, the camera may not operate
normally.
o
Pin 3: PAL/NTSC system selection of Camera. DO NOT CHANGE
THIS PIN.
APPLICATION DIAGRAM
Monitor
Cabling Terminal Block
