Oki MC560 MFP CX2032, Руководство по обслуживанию и устранению неисправностей

Страница: 34 / 91

34
Setup of self-diagnostic function
This self-diagnosis is practiced to Enable/Disable the error detections of the different types of sensors.
The error detections can be disabled or enabled temporarily for troubleshooting purposes. However, this function
should be exercised with utmost care, since it is able to set some items that require specialized knowledge in the
field of operation of the engine. After the function has been used, the set values must always be reset to the
defaults.
1. Activate the self-diagnostic (Level 1) mode, and press and hold down the [MENU+] key or
[MENU-] key, until the following message appears.
2. Pressing the [ENTER] key causes the following message to appear. Press and hold down the [MENU+] key or
[MENU-], until the intended item (See the table below) is displayed.
3. Pressing the [ENTER] key allows to select the set value in the lower line of the display section. Pressing the
[MENU+] key increments the set value. Pressing the [MENU-] key decrements the set value.
4. Pressing and holding down (3 sec) the [ENTER] key while the value you want to set remains displayed
registers that value on the EEPROM. Then, the status of Item 2 will be restored.
5. Repeat Items 2 to 4, as needed.
5. Press the [BACK] key (except for the status of Item 4.) to terminate the setup. (Status of Item 1 restored)
Indication Set Value Function
FACTORY MODE For setting the Factory Work mode (Fuse-cut disabled mode).
FACTORY
MODE
SHIPPING MODE For canceling the Factory Work mode and enabling the
fuse-cut function.
BELT UNIT ****** For checking the FUSE status of the transfer belt unit.
FUSE UNIT ****** For checking the FUSE status of the fuser unit.
K-ID UNIT ****** For checking the FUSE status of the K-ID unit.
Y-ID UNIT ****** For checking the FUSE status of the Y-ID unit.
M-ID UNIT ****** For checking the FUSE status of the M-ID unit.
FUSE INTACT
Note: ****** is
either
INTACT or
BLOWN.
C-ID UNIT ****** For checking the FUSE status of the C-ID unit.