46
Using the Wireless LAN Interface
To print using the Wireless LAN model, you need to have a
properly configured wireless LAN set up. You must configure the
printer to share the same network settings in order to establish
communication.
1. Check the DIP Switches.
• The printer’s DIP switches are factory set for WLAN
operation.
• Check that DIP switch 1 is OFF and DIP switch 2 is ON.
• If you need to reset other switches, refer to the full DIP
Switch table in the next chapter, “DIP Switch Settings”
.
2. Set up a connection to the Wireless Network.
• Ensure that your printer is configured with the proper
- IP address
- Subnet mask
- Gateway
- SSID
- Channel
- WLAN mode
- Security settings
• Refer to your MIS personnel for details of your existing
wireless network settings.
Note:
When printing with the WLAN interface, the usable range
between the printer and the host may vary depending on
the usage environment and the capabilities of the
connected devices.
Содержание LP470b
Страница 1: ...User s Guide 59318101 my okidata com LP470 LP480...
Страница 22: ...22 Right Side 1 DIP Switch Cover 2 USB Port Cover 3 Battery Compartment Cover 4 RS 232C Port Cover...
Страница 31: ...31 3 Push aside the gray latch 2 in the compartment and pull out the battery 3 4 Close the battery cover...
Страница 65: ...65 6 Turn the printer upside down and reinstall the battery pack...