Oki IP-5630, Руководство пользователя

Страница: 42 / 265

42
Loading the media
6
Raise the pressure roller up / down lever.
Note
‹
There are three selectable positions (up, middle and
down) on the pressure roller up / down lever. To raise
(release) the pressure roller here, raise the pressure
roller up / down lever to the top position.
Note
‹
Switch over the pressure between the pressure roller and the grit roller used for media feeding to match different
media. The bottom position is normally used. When skew occurs in the media and the media cannot be fed or when
using a media with weak elasticity such as a thin cloth, switch to [weak], the center position. The pressure force is
switched using the pressure roller up / down lever. (See figure below.)
<No pressure> (top)
When loading the media, raise the lever.
This the normal UP position.
[Rear] [Front]
<Weak> (in the center)
The pressure becomes weak.
<Normal Pressure> (bottom)
When the media is loaded, lower the lever.
It is the normal DOWN position.
7
Feed the media between the pressure roller
and grit roller and advance the media until
the leading edge of the media comes out of
the front cover.
Advance the media until the leading edge of the media
comes out at a distance of 200 mm.
When the leading edge of the media comes out of the front
cover, a confirmation beep sounds.
Notes
‹
Depending on the environment, the media may stick to the paper guide and may be hard to advance. In this case,
advance the media while raising it from the paper guide by holding both edges with hands.
‹
If the leading edge of a media is curled up or curled down, the media may be caught in the printer or may not be
properly set. If the media is curled too much, do not use it.
‹
Be careful that the leading edge of the media does not touch the front cover. If the roll media tends to roll, stretch it
to eliminate the rolling before loading.
‹
Check that the media edge guard does not enter under the media.