43827101TH Rev.2
142 /
Oki Data CONFIDENTIAL
6. Press the [BACK] key (except for the status of Item 4.) to terminate the setup. (Status of Item 1
restored)
K ** ** ** ****
xxxxxxxxxxxxx
** ** ** **** : Rev No.
xxxxxxxxxxxxx : Serial No.
Indication
TONER SENSOR
BELT UNIT CHECK
ID UNIT CHECK
REG ADJUST ERROR
DRUM OVER LIFE
Operation of set value
Detects.
Does not detect.
Checks
Does not check.
Checks
Does not check.
Detect.Stops.
Does not stop.
Does not extend life.
Extends life.
Function
For enabling/disabling toner sensor operation.
For enabling/disabling checking operation for
mounted belt unit.
For enabling/disabling checking operation for
mounted ID unit.
For enabling/disabling the stop of error issuance,
based on color drift detection value.
For enabling/disabling extending the drum life.
Set value
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
STOP
CONTINUANCE
Hatched part: Denotes the default.
5.3.2.12 Indication of LED head serial number
This self-diagnosis is practiced to check whether a downloaded LED head data matches the serial
number of the actual LED head.
1. Activate the self-diagnostic mode, and press and hold down the [MENU+] key or [MENU-] key,
until "LED HEAD DATA" appears in the upper line of the display section, and then, press the
ENTER key. (The MENU+ key increments a test item, and the MENU- key decrements a test
item.)
2. Pressing the [MENU+] key or [MENU-] key causes the serial numbers of the K/Y/M/C LED
head data to be displayed sequentially.
3. Press the [BACK] key to terminate the test. (Status of Item 1 restored)
Display Part
Upper
Display Part lower
Setting
Method
Set
Number
Set
Value
Deteils
Range Of
Selection
Initialing
Value
WR POINT
REV
BOTTOM WRT
POINT
-
-
TBL=**H
TBL=**H
±
=*.***mm
±
=*.***mm
00H~FFH
00H~FFH
0.000mm
(00H)
00H~FFH
(00H)
The correction value is
added to the predetermined
writing position
The amount of the form rear
end cutting is set