Troubleshooting > 51
>
To remove a sheet just entering the fuser , separate the trailing edge of the sheet
from the belt, push the fuser pressure release lever (1) towards the front and
down to release the fuser’s grip on the sheet, and withdraw the sheet through the
drum cavity area. Then allow the pressure release lever to rise again.
9.
Starting with the cyan image drum unit nearest the fuser, replace the four image
drums into the drum cavity, making sure to locate them in the correct order.
>
Holding the complete assembly by its top centre, lower it into place in the printer,
locating the pegs at each end into their slots in the sides of the printer cavity.
10.
Lower the top cover but do not press down to latch it closed yet. This will protect the
drums from excessive exposure to room lighting while you check the remaining
areas for jammed sheets.
NOTE
If the sheet is well advanced into the fuser (only a short length is still visible), do not
attempt to pull it back. Follow the next step to remove it from the rear of the printer.
1. Cyan cartridge
2. Magenta cartridge
3. Yellow cartridge
4. Black cartridge
1
1
2
3
4
Содержание C3000 Series
Страница 1: ...User s Guide C3600n C3600...
