3
4
Operation Guide
Operation Guide
Lower
Higher
Adjuster
Frame
Shelf (lowest)
Power tap
Plug
Wiring Cap
Wiring hole
Wiring Cap
Cord
Power tap
Plug
Wiring Cap
Wiring hole
Wiring Cap
Planter box
front
board
Planter box
Planter box
■
Adjuster operation
The product height can be adjusted within the
range of 0 to 20 mm by rotating the adjusters at the
bottom of the body. When installing the product,
operate the four adjusters to keep it horizontal.
Be sure to perform height adjustment with more than
two people using extreme caution so as to prevent
your hands and fingers from getting caught.
Caution
■
Wiring
In case of an office floor, wires can be raised
from the lower portion of the frame unit. Install
a power tap in advance.
[Wiring procedure]
①
Remove the lowest shelf.
②
Fully push the wiring cap into the wiring
hole so that the hole will be open. Insert
your plug into the power tap installed inside.
Pass the cord extending from the plug into
the wiring hole. Make sure the plug is firmly
inserted into the tap.
③
Re-attach the shelf.
When lowering the shelf, be careful not to have your
fingers caught between the shelf and the frame.
Caution
When lowering the shelf, be careful not to damage the
cord. Failure may damage the cord to cause a fire or
electric shock.
Warning
■
Planter box (option)
◦
The planter box does not come with any plants.
Use our Interior Green Small-Pot Series products available separately or your
prepared artificial plants.
◦
For this product, we recommend artificial plants.
◦
If water is splashed onto the body, immediately wipe it off with a dry, soft cloth.
If the body is left wet for a long time, it may rust.
[Removing the front board]
①
Hold and lift the front board by both hands.
②
While rotating and pulling the lower portion
of the front board toward you, remove the
board.
③
Put plants in the planter box.
When re-attaching the front board, carry
out the above steps
①
and
②
in the reverse
order.