Desktop Shelf Installation and Usage Procedures
Installing on the Desktop
This can be set at any height for the desktop.
<For Desktop Compact Desk>
Screw in the single-end connection bolts to one
location each on the right and left sides at the
location shown in the figure for the desktop.
Align the single-end connection bolts with the
holes on the back side of the desktop shelf,
insert the desktop shelf, and turn the screw-
type connectors clockwise to tighten.
Screw in the single-end connection bolts to one location
each on the right and left sides at the location shown in
the figure for the desk desktop.
Align the single-end conection bolts with the holes on the
front side of the desktop shelf, insert the desktop shelf,
and turn the screw-type connectors clockwise to tighten.
<For Desktop Extension Desk>
*When removing the desktop shelf, perform the above
procedure in reverse, and turn the screw-type connectors
so that the arrow is pointing downward at the position in
the figure (both right and left), and remove the desktop
shelf by lifting it up.
<For Desktop
Compact Desk>
<For Desktop
Extension Desk>
Screw-type connector
(this one is used)
Single-end
connection bolt
Single-end
connection bolt
Single-end
connection bolt
Screw-type connector
(this one is used)
Single-end connection bolt
Nut cap
Desktop shelf
Dowel holder grooves
Screw-type dowel (8mm)
When installing under the desktop
Be sure to perform this procedure before mounting the desktop.
This can be installed when the height of the desktop is JIS5 or JIS6.
Screw the screw-in dowels (8mm) into the dowel mounting
holes of the inner side of the side panels.
Dowel holder grooves are located under the side panel of the
desktop shelf.
Lower the desktop shelf from above so that these grooves
and dowels are aligned.
Remove the connecting bolts of the desktop, and mount the
nut caps onto the nut holes.
Store the removed single-end connection bolts in a safe
place.
* Remove the 3-drawer wagon unit.
Before changing the installation location of the desktop shelf being used,
remove all items on the shelf first. Also, be sure to remove the movable shelf
before performing any assembly work.
CAUTION
Movable shelf usage procedure
The depth of the movable shelf can be adjusted to
one of two levels by changing the mounting
location.
Depth extension procedure
Remove the movable shelf and shelf holder wires, and
mount the shelf holder wires to the front of the lower
level.
Align the side panel edge groove of the movable shelf
with the shelf holder wire, and press inside.
*Before removing the movable shelf, remove all items on the
shelf first. Otherwise, they could fall off during the extension
procedure and cause an injury.
Shelf holder wire mounting position
Compact
position
Extension position
Removal of movable shelf
Shelf holder wire
Movable shelf
Shelf panel depth adjustment