Mounting the Desktop (Compact type)
The height of the desktop can be adjusted to 5 levels based on the height of the person using it. Adjust the height of the desktop by referring
to “Height of Desktop” on page 8.
If lighting will be mounted to the desktop, be sure to
mount the lighting mounting clamp to the desktop unit
before assembly. (See page 9.)
CAUTION
Fig. A
Fig. B
Fig. C
Leg extension
Extension top panel
Screw-type bolt (2 places)
Leg
extension
Shelf
holder wire
The extension legs are positioned as shown in .
To change the extension leg position, flip the desk
backward, turn the screw-type connectors
counter-clockwise, remove the extension legs, attach to the
position in , and turn the screw-type connectors
clockwise to tighten in place.
Fig. A
Fig. B
Insert the shelf holder wires into the right and
left sides shown on the rear side of ,
and insert the extension top panel into the
shelf holder wires by sliding the extension
top panel from above.
Fig. C
Do not mount the bag hook to the hook mounting
position. The length of the bolt is different, and this
could damage the panel.
CAUTION
Desktop
Connecting bolt
(40mm)
Desktop dowel
Ring
Hook
Ring
Connecting bolt
(40mm)
*When the
optional 3 drawer
wagon upper unit
is not attached to
the desk, attach
nut caps to the
position specified
in the Fig.
Bag hook
(with bolt)
* One
connecting
bolt is left
over when
bag hook is
used.
Determine the height of the desktop beforehand, and mount the
desktop holder dowels into the dowel holes for the selected height
(2 locations each on the right and left panels)
Place the desktop on the desktop holder dowels to hold it
there temporarily.
*Mount all of the desktop holder dowels at the same height.
If any of the dowels are at a different height, the desktop
could become dislodged and is extremely dangerous.
When changing the height of the desktop, first
check that the desktop holder dowels are mounted,
and then remove the connecting bolts.
CAUTION
Securing the desktop and mounting the hooks
Once the desktop is put temporarily in place, insert the rings
into the outer holes of the side panels and rear panel that
match the height, and tighten using connecting bolts.
At this stage, the backpack hook can be mounted to
either the right or left side on the rear of the panel.
When mounting, secure the backpack hook together with
the supplied bolt to the desktop.
Next, if desired, mount the hook on the side of the desktop (1
available location on each side).