T1506-08
Desk
Thank you very much for purchasing the
OKAMURA Study DESK. Before using this
product, carefully read this Assembly
Instruction Manual in order to fully under-
stand and correctly assemble the product.
Assembly Instruction Manual
Special Edition
Assembly Final Drawing
(Name of each part)
Two
persons should
assemble this
product.
A cross slot
screwdriver is required for
assembly. Please have one available.
* Do not use an electric screwdriver
because it may damage the
product.
Side panel
Desktop
Divider
Rear panel
Swing hook
(Do not remove the warning labels)
Quality labeling seal
(Attached to the desktop back side)
(Attached to the
desktop back side)
Installation of desktop,
movable divider and hook
Insert the desktop receiving dowels of (4 locations) into the desktop receiving dowel
holes provided on the side panel, and place the desktop.
Insert the rings of from the outside holes on
the side panel and rear panel, and securely
tighten with the connecting bolts of .
At this time, the swing hook of or the hook
of can be installed.
* The hook and the swing hook can be installed to any of the front, rear, right and
left sides.
* When installing the hook and the swing hook, install the long connecting bolts of
. When not installing the hook and the swing hook, install the short connect-
ing bolts of .
Use of different bolts may result in damage to the parts and product.
* Desktop height is five-stage adjustable. Refer to page 3 for the height.
Movable
divider
Plug cap
Desktop
Rear panel
Notch
* Make sure to install all of the desktop receiving dowels at the
same height.
■
How to use movable divider
■
Installation of hook
There should be three connecting bolts (
+ ) remaining. Store them in a safe place.
Insert the resin parts of the
movable divider from the
right and left notches at
the back of the desktop,
slide it to install.
CAUTION
When changing the desktop height, check that the desktop receiving dowels are installed, and then remove the connecting bolts.
How to Remove Drawers
When you want to remove a drawer because an object
fell behind the back of the drawer frame, remove the
screws from the inside of the drawer frame member.
Then, the drawer can be removed.
Screws
b
e
d
e
e
b
a
b
h
f
g
Upper side
Assembled on rear face
Okamura Corporation
International Sales and Marketing Division
Address: 2-14-27 Akasaka, Minato-ku, Tokyo 107-0052 Japan
Phone : +81-3-5561-4085
Fax : +81-3-5561-4086
Website: http://www.okamura.co.jp/