Okamura 865JAD, Руководство по сборке и инструкция, Страница: 7 / 12

6 7
×
8
×
8
×
8
×
2
×
3
×
4
×
16
Desk
Fixation of desktop, installation of hook
Desk 5 Fixation of desktop, installation of hook
After temporarily placing the desktop on the desktop
receiving dowels, insert the rings of into the holes on
outside of the side panel, and tighten with the connecting
bolts of .
Install the swing hooks of on the right and left sides at
the positions shown in the diagram.
When only using the desk, install the plug caps of to the
upper part of the side panel to complete installation.
The movable divider attached to the bookshelf can also be
used for the desktop.
Insert the movable divider into the notch part of the
desktop and slide laterally to install.
Desktop
Swing
hook
Swing hook
* Proceed to the bookshelf assembly in a state that the desktop is
installed.
When using the product in connection with the bookshelf,
proceed to the bookshelf assembly on page 7.
a
b
b
b
b
g
a
a
a
a
f
f
f
f
a
b
When using the desk and bookshelf separately
Desk
Installation of movable divider
(at desktop height No. 2 through No. 6)
Movable
divider
Notch part
Bookshelf Details of Parts
(make sure to check before assembly)
Cap for insert
nut
Shelf receiving
fitting pin
(M6)
Actual size Connecting bolt
(M6 × 45mm)
l
Plug cap
(11mm)
Plug cap
(8mm)
e
m
f o
n
Single-end connection
bolt
(24mm/40mm)
c
Single-end
connection bolt
(24mm)
Fixed shelf
plate ×1
Rear panel
(upper) ×1
Rear panel
(middle) ×1
Movable divider ×4
Right side
panel
Turn clockwise to screw.
Right side panel Left side panel
Rear panel (lower) ×1
(Wider plate)
Movable shelf
plate ×2
Bookshelf
IInstallation of connecting bolt to side panel
Install eight single-end connection bolts of on the right and
left side panels.
Use a cross slot screwdriver for assembly.
* An electric screwdriver or electric tool may damage the product,
therefore, use a manual screwdriver.
Left side
panel
[About screw-type connector]
Screw-type connector
The screw-type connector is
tightened by turning clockwise.
The screw-type connector is
loosened by turning counterclockwise.
Screw-type
connector
Single-end
connection bolt
(Embedded into the members)
When the arrow is set to the single-
end connection bolt, the connecting
bolt is inserted (removed).
Arrow
Upper side
Assembled on rear face
[About connection bolt]
Single-end
connection bolt
When screwing the
connection bolts into
the insert nuts, make
sure not to tighten
excessively.
The insert nut may be removed,
or the head of the connection bolt
may be broken.