3
Procedures and techniques if not carefully followed- will result in damage to the
equipment. –will expose the user to the risk of serious injury, illness or death.
NOTE: The electric fireplace heater may emit a slight harmless odor when first turned
on. This is caused by activating the internal heater components for the first time and
should not occur again.
CAUTION
If you use this heater in conjunction with a thermal control, a program controller, a
timer or any other device that switches the heater on automatically. Remember to
observe all safety warnings at all times. The stove heater has safety overheat
protection. If the overheat protection trips, unplug the power cord from the receptacle.
It should reset automatically after 5-10 minutes.
A 15 AMP circuit is used to operate this heater. If the breaker trips when the heater is
used another location or unplug other appliances that are on the same circuit. If you
require an extension cord use one that is rated at 1875 watts.
Operating Instructions
Once the fireplace heater insert has been properly installed and connected to a ground electrical
outlet, it is ready to operate. Note: ensure the circuit breakers for the power supply are turned on.
The controls are located behind the grill below front glass and can be accessed by pulling the grill
up from the top, forward and down.
Lift front grill to access the switches.
1.0/I: Press this button for main power and flame effect. The indicator light will be on. See
below for other control switches.
2.1250W: For heat function - Press this switch while the 0/I switch is in the ON position. The
indicator light will be ON.
3.Temperature Control: To adjust the temperature to your individual requirements, turn the
